XENTRY Accessories

Image Slider

Accessories for XENTRY Diagnosis VCI (multiplexer)

The following accessories are available for XENTRY Diagnosis VCI in the Mercedes-Benz B2B Connect Shop:

  • OBD cable (16-pin)

  • A selection of adapters for different applications: 8-pin, 14-pin and 38-pin cable adapters

  • USB cable (5 m)

Accessories for the XENTRY Diagnosis Pad 2 (diagnostics computer)

The following accessories are available for the XENTRY Diagnosis Pad 2 in the Mercedes-Benz B2B Connect Shop:

  • Power supply unit including power supply plug

  • Docking station

  • USB hub

  • On-board electrical system charging cable (12 V /24 V)

  • Pad 2 pen

Accessories for XENTRY Scope (measurement technology)

We offer you the following accessories for XENTRY Scope to systematically expand the possibilities of the new measurement technology for diagnosing engine and electronics:

  • NVH kit (noise, vibration and harshness) for noise and vibration measurements

  • 100 A current clamp

  • 2000 A current clamp

  • Pressure sensor (-916 mbar to +12.5 bar, high speed)

  • Temperature sensor – Measurement range of the probe from -40 °C to +125 °C

  • High-frequency testing and measuring range probe for use with higher voltage signals up to 500 volts

  • Lead for resistivity measurement (30 V)

  • Coil and signal sensor for testing ignition coils and solenoid valves

  • Secondary ignition sensor (capacitive sensor for measuring the secondary ignition voltage at the ignition wire)

  • Small parts set (clamps & adapters) for connecting the probes

  • Optical balancing set for help with balancing rotating components

XENTRY Accessories Support

You can select the appropriate category under “Need help?”. If you cannot find a suitable answer in the FAQs, open a ticket at the bottom of the page.

Â