XENTRY Accessories
Accessories for XENTRY Diagnosis VCI (multiplexer)
The following accessories are available for XENTRY Diagnosis VCI in the XENTRY Shop:
OBD cable (16-pin)
A selection of adapters for different applications: 8-pin, 14-pin and 38-pin cable adapters
USB cable (5 m)
Accessories for the XENTRY Diagnosis Pad 2 (diagnostics computer)
The following accessories are available for the XENTRY Diagnosis Pad 2 in the XENTRY Shop:
Power supply unit including power supply plug
Docking station
USB hub
On-board electrical system charging cable (12 V /24 V)
Pad 2 pen
Accessories for XENTRY Scope (measurement technology)
We offer you the following accessories for XENTRY Scope to systematically expand the possibilities of the new measurement technology for diagnosing engine and electronics:
NVH kit* (noise, vibration and harshness) for noise and vibration measurements
100 A current clamp
2000 A current clamp
Pressure sensor (-916 mbar to +12.5 bar, high speed)
Temperature sensor â Measurement range of the probe from -40 °C to +125 °C
High-frequency testing and measuring range probe for use with higher voltage signals up to 500 volts
Lead for resistivity measurement (30 V)
Coil and signal sensor for testing ignition coils and solenoid valves
Secondary ignition sensor (capacitive sensor for measuring the secondary ignition voltage at the ignition wire)
Small parts set (clamps & adapters) for connecting the probes
Optical balancing set for help with balancing rotating components
*NVH kit for Mercedes-Benz Truck EU-VI not applicable.
XENTRY Accessories Support
You can select the appropriate category under âNeed help?â. If you cannot find a suitable answer in the FAQs, open a ticket at the bottom of the page.
